Puma 1.7VCT stalling

ProjectPuma

Help Support ProjectPuma:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Hi David This high idle problem has been discussed on the forum in detail previously . Try typing the key words into the search box .
If you draw a blank I will tie up time searching for it for you .

Off the top of my head though .
1)check the butterfly flap on the throttle body as carbon accumulation can cause it to stick when you release the throttle use carb cleaner and kitchen towels.
2) check the contacts to the throttle position sensor (TPS)on the end of the spindle are clean , spray them with electrical contact cleaner and the plug.
3) Check that all the bolts on both the inlet manifold joint and also to the head are tight .
As an airleak can cause this and check all air hoses and the rubber grommet joint at the servo
 

Latest posts

Back
Top