Recent content by eazy

In other cars (renault megane) If you have moved your seat the connector manages to get disturbed. I reckon just turn the car off ( You could disconnect the battery but I've never had to ) then wait 2 mins. Disconnect the plug. Examine it for any wear then reconnect. Usually puts the light out...

Was going to Dunoon and 1st time on the Arrochar Road, Used to be a good road I have never driven it, but I'm not too young to remember it. Just coming over a hilly bit and another puma past on the brae. Just spotted it like a flash for 1/3 second I think a Thunder ( I was having to concentrate...

Same rust as mine, I went in to tescos and left and the car was still there. I dont like to shop. Funny thing is when I whipped into the space I didn't even realise until It was pointed out to me by my beloved camera holder who just had to take a picture of me looking at my worse. Get back to...

Hi, was looking at my advisory on the last MOT my puma had which is up on 27th May. Under advisory it says;- Corrosion on comps and structure // steering and susp slight // b.pipes // shocker. Its the Corrosion on comps and structure thing i'm wondering what might the 'comps' mean. Pulling...

Aye seen the picture of it, 2 wires (maybe soldered, maybe even glued who knows) onto a 16 pin chip. 0 bids. Seller information trevorthomas10 (33938 Feedback score: 33938) 99.9% Positive Feedback He does sell loads of flower seeds they must be real. :-P

Would this thing even work? I'm a bit suspicious. http://www.ebay.co.uk/itm/TUNING-CHIP-Ford-Galaxy-KA-Fiesta-Fusion-Puma-Transit-Petrol-Diesel-Engine-/141629866690?pt=LH_DefaultDomain_3&fits=Car+Make%3AFord%7CModel%3APuma&hash=item20f9cc42c2

Now that I put a piece of wire bridging the the gap in the fan resistor plug the fan will come on when at temperature. And the car is ok when stationary. When the car is moving it seems ok until I close of the heater then the temp will shoot right up, sometimes the fan comes on sometimes not...

Are these resistances correct? Testing both my old and new ECT Sensor the reading I'm getting on both using a freshly boiled kettle is 3.50 with the multimeter set to 20k (only reads 1 . if lower). So if I'm doing it right then thats 3,000ohms near 100 deg cel. :? I got the new one from...

Thanks guys, I don't mind working on the care. Just wish the rain and wind would stop :)

I suspect they do make loads of panels but I would have thought the A/C would light up as my broken one does. It wouldn't take too much to solder the part/transistor in from the one I got I guess.

Hey, my handbrake isn't working good any more and My clutch is about to give (mixture of its age, my limited driving experience being that I still have L plates on, and handbrake/hills etc). I also here the clutch on these things slip quite a bit? Brakes aren't that good to begin with I...

Found a puma in the scrappys :) hose was perfect.

Hi, I picked up a control panel in the scrapyard today from a fiesta. Didn't have the cigarette lighter part so I whipped out the printed circuit board and seems the same except it had 2 extra bulbs on the switches. Put it in the puma and now the HCV works. :) Cold air now. But the A/C doesn't...

Update :- Thinking the resistor is ok, I realised my rad wasn't getting hot. Changed thermostat rad now gets hot. But then water was escaping somewhere else. Found a slit in the HCV hose that goes to the engine. The short one on the nearside. I want to go to scrappys tomorrow and acquire one...

See the resistor on the fan, does tat have a technical term. keep trying to find them on google, amazon but can only find HCV's