Well it has been a while since I last updated this.
Since the body work and respray was done by Legend Vehicle Specialists, nothing else has actually been done to the car, but the planning is well underway for the next steps.
The car has now been sorn'd and sitting miserably.
So for the next stage which is looking to be actioned at the end of January / beginning of February
FRP Knuckles to be stripped down, powdercoated, longer hub bolts fitted along with new bearings, circlips and new front ABS cables
FRP Wishbones powdercoated and fitted with new ball joints
Subframe powdercoated
FRP HD Driveshafts powdercoated and fitted with new CV boots
Rear beam to have extension modification and powdercoated
All new subframe, wishbone and rear beam bolts fitted
Front 10mm spacers replaced with 20mm front spacers
Rear beam 30mm spacers replaced with 40mm billet spacers
Collar sleeves fitted to FRP knuckles to house coilovers
Brand new Coilovers (Maybe GAZ)
Brackets made and fitted for front Alcon Calipers
Focus RS 325mm Front discs fitted
Escort rear ABS loom fitted
Rear Disc splash plates powdercoated
Cosworth Forged Low compression Pistons fitted
Forged PEC Rods fitted
New Piston rings fitted
LMS1T Cams fitted
LMS Stage 3 Head
Keyed Crank
Baffled Sump
HD Valve springs
Knife Edged Throttle Body
Oil return to sump correct and new sump gasket
Garrett GT2860R Turbocharger fitted
Downpipe corrected for new turbo.
New ARP head bolts
New ARP Crank cradle bolts
Decompression plate removed
Cometic Head Gasket fitted
New Cambelt & Tensioner fitted
New Oil pump fitted
AC Pump removed
Fiesta PS pump fitted
Focus belt tensioner fitted
New Head gaskets set
New Battery fitted
Custom built gearbox, lsd and cable linkage fitted
New Bailey blow off valve fitted
New Oil catch tank fitted
New Backbox fitted to exhaust system
Oil pressure sensor fitted
New Sparco Evo 3 Seat fitted (The Rev Plus was a tad..... tight lol)
Dashboard Flocked
Bespoke door cards (Still considering designs)
Black flooring fitted
Support dials wiring corrected
Sequential shift lights fitted
Windscreen washers re-routed to wipers not bonnet
Rear bumper heat protection fitted
Kevlar sheeting fitted to sides (stone chip areas)
Lexan windows re-sealed
New Side repeaters
New scuttle panel and battery cut off mounted 180 degrees
Other future additions will include:
Multipoint Roll Cage
K6 Emerald ECU with launch control and triple maps
Rear Rain lights fitted
Bonnet lamp pods fitted
Plumbed in Fire Extinguisher System fitted with two handhelds fitted
Upper 20-40ltr Fuel reservoir fitted to existing fuel cell
Second Sparco seat fitted inc 3in 4pnt harness
Intercom system
Interior trims removed and interior painted
A mighty list to get through, but a good amount of progress should be made in the next 4 months.