rocker cover gasket change help

[67911121km]

So, I've got the gasket and some sealant, and I'm going to follow the "how to" guide on here which looks easy enough to follow.

My only question is about tightening up the "3 x 10mm bolts securing the upper portion of the cam cover" when I'm finished... Should these be tightened up to a specific torque? There's no mention in the guide.

Many thanks

 

[lusid666]

iirc, they all are tightened to 10nm.

 

[67911121km]

iirc, they all are tightened to 10nm.

Thanks lusid666 - I know the four nuts securing the rocker cover are def 10nm but I wanted to check on those other three nuts too.

 

[ElDude at Allison Automotive]

Just use your common sense... small wrench and don't over tighten..it's only an M6 thread from memory..

 

[67911121km]

Just use your common sense... small wrench and don't over tighten..it's only an M6 thread from memory..

thanks dude