Hey guys...anyone watching this thread? I wanna make a brake upgrade for my 2001 Puma and besides the st150 what other options do i have? Im not in the U.K. anymore im.in Romania...cheers
Bruv i think its the bloody VSS its causing a lot of problems...i checked for leaks everywhere...i bought a VSS aftermarket it worked fine for a short while then its causing problems again...i think i will get a genuine ford one so i wont bother...theese sensors are so poor if they are not...
Heya tnx for the reply , i manage to change it , i have another puma for spares , there is a bracket at the bottom at the radiator , unscrew it , lower it , then pop the fan out and then lower it and slide it :) now it works fine ...cheers
Quick question guys i need to change the radiator fan and i dont have a lift or something and i cannot see the screws or something...is it difficult to change the fan? It only starts on the second level and its screwing up my AC system putting too much pressure on it...cheers
Wild E i found the culprit :( was mostly my fault cause i didnt check the VSS properly , the wires inside were mushed but the speedo and mileage were fine...after i disconnected the bloody vss the engine runs smooth as it should
B are u still on here? Mate i have the same issue and its driving me nuts... Wild E tried to help me but i couldnt find the problem :( i have a feeling this is caused by a leak somewhere but i couldnt find it...u didnt say if u fixed your problem and how u fixed it :(
Hello guys , the brake booster is hissing after i turn off the engine. Brakes are fine while driving. Also when im coasting in neutral the idle sits higher than usual and revs are going up and down 1300-1600 rpm. No leaks on the manifold side . No hissing while driving... Check valve gone bad...
Wild E new development...after i shut down the engine and open the bonnet i hear a hissing by the brake booster...after doing a little research it sounds like the check valve in the booster is bad...do u think a bad check valve can cause a vacuum leak and make the engine run bad? Brakes are...
Ive just change it today...still doing the same crap i swear it drives me mad i feel like would torch the damn thing now :( my third puma its a nightmare :(
Wild E unfortunately my ghost have returned :( i connected the computer with ford program and i got the p0135 error...the o2 heating issue...although i get theese symptoms when the car runned for a while...any ideea if the o2 sensor can cause that oscilation? I reset the ecu it runs fine for...
Hopefully so....thats why i cleaned the maf at some point so i can rule it out...probably was a leak that i covered it with the sillicone ... But i could see its fixed only after i reset the ecu....ill see today how its running...cheers for the help :)