Search results

Gray fitted Puma mats. In good condition. Can post. £50 posted

1 genuine reconditioned steering rack, bought but never fitted, same as this one- https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.co.uk%2Fulk%2Fitm%2F251664179960 Never fitted so as new- £90 posted. Genuine Ford mudguards x4 (front and back), never fitted, bags have been opened...

Rusty floorpan https://imgur.com/gallery/Fj7zr96 Have had this Puma Black sitting a couple of years. Did some repairs to drivers footwell. Didn't look properly at the rear.. had a look today and it looks fekked. It's a lovely wee car with relatively low miles- needing a few other jobs done but...

For sale. Year 2000 W plate silver 1.7. Circa 120k well looked after miles. Maintained and serviced. Flowed maf, machined throttle body, cone feed pipe/cone filter. cat back exhaust, dropped 30mm, all suspension renewed in last 18 months, new clutch and master cylinder. Standard interior with...

Bought this brand new a few months ago to help fit some seats, fitted briefly but now surplus to requirements. Cost £110 new, £50 posted, £40 pickup from Glasgow. Pm me on here if you're interested. Allan.

Pair of the above seats, in vgc, no rips or tears. Come with one almost new Corbeau subframe/sliders and one modified focus subframe. This sits a bit high and could prob do with being cut and welded to make it sit properly- fits fine just a few inches higher. Seats are great but trying to raise...

Was lucky enough to be given this- Needs a steering rack, rear mounts and welding on either side behind the sills. Knew it had a damp/mould problem from somewhere in the drivers footwell so lifted the carpet, cut out the damp insulation and got out the wire brush and found these.. Anyways...

Right so fitted 40 mm lowering springs and new rear shocks yesterday. Front had new shocks 6 months ago and springs went on fine. Rear shocks built up as per the guide on here and looked like this built up: All seemed fine then put the car back on its wheels, realised that this was happening...

Anyone ideas about this?? Reassembled with the circling as advised in the how to on here... let the jack down and the stick up by a couple of inches and moving freely? Monroe shocks and springs look similar!

Changing from standard disks to 280 st ones. Rounded the existing caliper bolts and trying to sort replacements from Ford. Anyone know the part no at all? Will need to reuse the old bolts as the donor didn't come with any. As far as I know this should be fine? Ta in advance, Allan.

Aye up. Looking at getting one as I've tried the super bright bulbs and not that great an improvement. Tried rubbing the outside and cleaning inside the inner surface but to no avail. Any recent recommendations of a decent kit from eBay? TIA, Allan.

Been told a while back by a garage that one is corroded and the mot is looming. I have wishbones, droplinks and trackrod ends to fit but was thinking of doing shocks and top mounts too. Only issue I have is that I'm concerned the top spring mount corrosion might be a fail? Cant seem to find new...

Hi folks. Doing the front wishbones/drop links and track rod ends at some point soon for the Mot next month. Have had the classic intermittent abs problem on and off since I bought it a few months ago. Anyway- was having a quick look today and noticed this when I had the wheel off- Tone ring...

..but going to see one tomorrow.I'm no mechanic but have done plenty of basic spannering and just looking for general advice I've had a look on here,know about the rear arches etc.. going to see 2000 1.7 thats done just over 100k. The seller has been honest about a dent, front bearing, arches...