Recent content by WikkidPuma

It absolutely worked my friend, thanks again. =D

I shall swap the connection and get back to you, I am over the moon. Due for an MOT this afternoon. =DD. Can't thank you enough.

Positive

Pin 3 does not lose voltage at all

When switch is on and car is off, pin 1 shows 12v to ground When car is off and Switch is on, pin 1 receives 12v. pin 2 receives 0v. When car is on pin 1 receives 12v. Pin 2 receives 12v also.

Correct

You may have to be more specific, on K46? Which pins would be 2 or 3? Sorry =D

F28**

Irst? Forgive me as i am no mechanic 😎

K45 removed and still does the same thing,, f24 (15 amp) removed and lights on dash come up I can then put fan on but the car doesn't start, and cuts out if I take it out while running.

Hi, have a 1999 1.7, wired a switch Into pin 17 (disconnected from ecu) of the Tape ecu which should be the high speed fan relay. Fan comes on when switched only when the car is off. However, when the ignition Is on and/or the car is running the fan turns off. Any ideas would be massive. Thanks.