Search results

ProjectPuma

Help Support ProjectPuma:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. M

    puma 1.4 newer engine

    hi, I've just re-purchased my old 1.4 puma to go alongside my 1.7 puma. it still runs fine but it has done 150 000 miles. I've spotted a 1.4 engine in a breakers yard near me, however its a 2010 fiesta with 38 000 miles on it. I was wondering if it would be possible to do an engine swap using...
  2. M

    Fiesta in the Park - 8th May 2016 - Huntingdon

    Hi, I'd like to go to this - Fiesta in the Park - show, how do I book a ticket ?
  3. M

    sill repair panels

    hi, I was wondering if it was possible to get sill repair panels as my puma needs some repair work in that area and would rather to it properly with a new sill instead of having patches welded here and there, thanks.
  4. M

    1.7 into 1.4

    hi there, is it possible to fit a 1.7 motor into a 1.4 puma or is the loom different and would the drive shafts slot into a 1.7 gearbox ?
  5. M

    1.7 inlet cam timing issue, please help !

    Hi all, I need my puma by the week end but decided to change the cambelt today. I bought the tool to lock the cams and the pin to find tdc on the crank. I have slackened off the cam pulleys using the hex cast into the cam to hold it as instructed and am now ready to tighten them again and check...
  6. M

    cam belt / oil leak advise please

    Hi again, I've got an oil leak on the right hand side of my engine which I initially thought was the rocker cover seal but it isn't, so i'm assuming its either the crank or more than likely the cam shaft seals. Either way the cam belt has to come off which has only recently been fitted before...
  7. M

    another oil leak

    hi again, having sorted the gearbox oil leak thanks to info provided on here, I have now noticed another leak on the other side where the pully's are. when I shine a torch up from underneath its hard to work out where its coming from as everything seems to be covered in it. all the levels are...
  8. M

    gearbox oil level

    I checked the oil level today and it is clean and just over 1cm under the hole. the oil is thin compared to what I normally call gearbox oil - ep80 etc - but I guess its just modern oils that are more advanced.
  9. M

    gearbox oil level

    hi, I recently posted a topic on here about my gearbox oil leak which was correctly diagnosed as being the breather being the wrong way round. however, it must have been quite a leak as there was a lot of cleaning off to do underneath where everything was covered in oil. my question is, how do...
  10. M

    door handle removal ?

    hi, I've just purchased another door handle off ebay to replace the chipped & scratched one on my puma but I cant work out how to remove the existing one. do you have to take the glass out to get to the screws ?
  11. M

    gearbox oil leak

    after inspection today is seems that the breather has indeed been put on the wrong way as the arrow was pointing to the rear instead of forward. I shall clean around the area and put it back in the right way. is there any way of checking the level of the gearbox to see if it has lost some oil...
  12. M

    gearbox oil leak

    that's what I thought so I mopped it up and then it came back again. thanks for the info, i'll check tomorrow and see what I find.
  13. M

    gearbox oil leak

    the car was born dry before the clutch was changed so that will rule out the rocker gasket, where is the gearbox breather situated as i'll check tomorrow and is it obvious which way it should go ?
  14. M

    gearbox oil leak

    hi all, a friend of mine took their puma in to get a new clutch put in and since they've had it back it has had an oil leak. when I've had a look it seems to be in the area where the hydraulic pipe goes in to operate the clutch as it is pooling in the little crevices and running down the side of...
  15. M

    knock noise on front end

    thanks for the reply's i'll check the anti roll bar tomorrow and update.
  16. M

    knock noise on front end

    hi all, had my puma a few months now and it always had a knock on the nearside front when going over bumps etc. last week I changed the front shocks and springs and had a chance to look around for any signs of wear and tear but nothing stood out as being excessively worn. it has had new drop...
  17. M

    abs light on after maintenance

    Fixed it now, school boy error, I hadn't pushed the plug in far enough ! doooooooh !
  18. M

    abs light on after maintenance

    thanks for the reply's i'll have a look tomorrow.
  19. M

    abs light on after maintenance

    yes I've driven the car but just round the block.
  20. M

    abs light on after maintenance

    hi there, I've had the front struts out on my puma which resulted in me un plugging the wire to the abs sensor, when I put it all back together again the abs light stays on now. is this normal, does it have to be reset or have I damaged something ??
Back
Top