yes I doDOH said:Do you have a spark from a plug lead with plug inserted and earthed on the rocker cover, when cranking over the engine?
Hi thanks for a reply. Would an ohm reader all reading at 15 ohm not be as sufficient? Could it still be faulty?mmc757 said:A noid light is a simple and inexpensive way to confirm fuel injectors are getting a signal.
https://www.ebay.co.uk/itm/Sealey-VS213-Noid-Light-Set-6pc-Fuel-Injector-Signal-Fault-Test-GM-Ford-Bosch/303871650228?epid=1205517355&hash=item46c02969b4:g:ieUAAOSwpIRgGsDi
The noid light confirms that the injectors are actually being signaled to open. Measuring resistance only determines shorts or opens in circuits.Alex11jg said:Hi thanks for a reply. Would an ohm reader all reading at 15 ohm not be as sufficient? Could it still be faulty?mmc757 said:A noid light is a simple and inexpensive way to confirm fuel injectors are getting a signal.
https://www.ebay.co.uk/itm/Sealey-VS213-Noid-Light-Set-6pc-Fuel-Injector-Signal-Fault-Test-GM-Ford-Bosch/303871650228?epid=1205517355&hash=item46c02969b4:g:ieUAAOSwpIRgGsDi
Thanks again to all of you taking time to give some advice. She’s booked in next Tuesday if I can’t get anything out of her the weekend. I’ll be sure to let you know when I find out
Hi, on my mechanics 1st glance he thinks gasket, he’s going to do a compression test today. Be gutted if it isDOH said:Alex , You mentioned earlier that you had driven through water . In view of the fact you have sparks at the plugs and fuel at the injectors .
Then the next thing to check is do you have compression?
I am beginning to wonder if the cam belt has broken or stripped a tooth. Any ideas when it was last changed?
It may have also gone hydraulic if the water was deep enough damaging the rods and pistons?
Are you certain you last filled up with petrol and not diesel?
You could either borrow a compression tester , you will need the long reach thread adaptor or a long reach rubber cone type of push on and hold there adaptor for whichever tester you can use.
You could also undo approx 4x 10mm socket bolts and pull the front cover back slightly to see if both cams move when someone cranks it over for you.
So what was the diagnosis from the garage?Alex11jg said:She’s booked in next Tuesday if I can’t get anything out of her the weekend. I’ll be sure to let you know when I find out
Enter your email address to join: