Hi, I will post in the newbie thread at some point
I recently purchased a Puma and noticed the drivers side door card was rattling/loose. So I ordered some replacement door card clips from ebay which were described as a replacement to the OEM Ford ones but they honestly don't seem to fit correctly.
This is how I approached the job: with the door card completely removed I pulled out all 8 clips from the door card (some came out whole), I then went and got rid of the remaining bits of plastic from the door itself.
I then installed the clips as a whole into the 8 sections in the door card and made sure I lined up the bottom ones into the holes in the door and pressed them in as much as I could with a bit of fist bashing the door card (not extremely hard) but some went in and some snapped completely.
I'm now left no better off, the door card still isn't clipped in fully.
Am I doing it wrong? Thanks.
I recently purchased a Puma and noticed the drivers side door card was rattling/loose. So I ordered some replacement door card clips from ebay which were described as a replacement to the OEM Ford ones but they honestly don't seem to fit correctly.
This is how I approached the job: with the door card completely removed I pulled out all 8 clips from the door card (some came out whole), I then went and got rid of the remaining bits of plastic from the door itself.
I then installed the clips as a whole into the 8 sections in the door card and made sure I lined up the bottom ones into the holes in the door and pressed them in as much as I could with a bit of fist bashing the door card (not extremely hard) but some went in and some snapped completely.
I'm now left no better off, the door card still isn't clipped in fully.
Am I doing it wrong? Thanks.