spike.
New member
Refer to this video on how to remove the light, while following directions below
VIDEO HERE
- open bonnet
- remove the centre grill (2 screws)
- remove the screw on top of light on wing
- remove the screw on rotating clip
- rotate clip to open position
- wiggle out light, unclip drain hose, and unplug the connector
- protect lens, move aside the two silver clips, and remove rear cover
OFFSIDE
locate the silver lever as in this picture
[fullalbumimg]1215[/fullalbumimg]
To convert the Offside lamp unit. The the sliver shutter clip must be moved down and across to lock it into position (arrowed). On some vehicles the clip may not stay in position by itself. In his case the clip can be held in place with a small self tapping screw being inserted into the shutter clip channel.
[fullalbumimg]1216[/fullalbumimg]
NEARSIDE
locate the silver clip as in this picture
[fullalbumimg]1217[/fullalbumimg]
To convert the Nearside lamp unit. The the sliver shutter clip must be moved down and across to lock it into position (arrowed). On some vehicles the clip may not stay in position by itself. In his case the clip can be held in place with a small self tapping screw being inserted into the shutter clip channel.
[fullalbumimg]1218[/fullalbumimg]
- refit rear cover, using two metal clips
- plug in wiring connector, good idea to clean with switch cleaner
- locate drain hose in clip
- wiggle light back in
- rotate catch
- fit the 2 screw
- refit grill & its 2 screws
VIDEO HERE
- open bonnet
- remove the centre grill (2 screws)
- remove the screw on top of light on wing
- remove the screw on rotating clip
- rotate clip to open position
- wiggle out light, unclip drain hose, and unplug the connector
- protect lens, move aside the two silver clips, and remove rear cover
OFFSIDE
locate the silver lever as in this picture
[fullalbumimg]1215[/fullalbumimg]
To convert the Offside lamp unit. The the sliver shutter clip must be moved down and across to lock it into position (arrowed). On some vehicles the clip may not stay in position by itself. In his case the clip can be held in place with a small self tapping screw being inserted into the shutter clip channel.
[fullalbumimg]1216[/fullalbumimg]
NEARSIDE
locate the silver clip as in this picture
[fullalbumimg]1217[/fullalbumimg]
To convert the Nearside lamp unit. The the sliver shutter clip must be moved down and across to lock it into position (arrowed). On some vehicles the clip may not stay in position by itself. In his case the clip can be held in place with a small self tapping screw being inserted into the shutter clip channel.
[fullalbumimg]1218[/fullalbumimg]
- refit rear cover, using two metal clips
- plug in wiring connector, good idea to clean with switch cleaner
- locate drain hose in clip
- wiggle light back in
- rotate catch
- fit the 2 screw
- refit grill & its 2 screws