induction hose

[luke]

not essential but i could do with a new induction hose with a straight bore not convoluted like the original one.
does anybody know the two diameters as it needs to reduce down from the maf to the tb.
90degree one would be fine so i can stick the cone behind the bottom grill.
any ideas where i can get one?
cheers

 

[EvilDonut]

Did you ever find this out? I need to know too! I did a crude measurement without taking the hoses off and it looks like the TB and MAF outlet are both 80mm, and the MAF inlet is about 85mm. I doubt these are accurate though! It does look like the hose reduces from the MAF to the TB but I'm not so sure it actually does, its just the standard pipe varies its diameter in the middle I think.

 

[Marcus000]

http://www.projectpuma.com/viewtopic.php?f=19&t=6904&start=25" onclick="window.open(this.href);return false;

 

[EvilDonut]

Aye I found that earlier, does that apply to the 1.7 though? The sizes are definitely bigger than 60mm on the 1.7 - I just measured the standard airbox outlet ID and its about 85mm.

 

[Marcus000]

Ah oki doki, don't know then, I only have the 1.4! :grin: