mihalyn90
Member
- Joined
- Nov 24, 2015
- Messages
- 531
Hello,
So after the thing, I managed to print out on a sticky paper my own cluster design.
Question, ok i can remove my dash after disconnecting the cable from the gearbox. All fine... I can pry it open... that too...
But after removing the needles do i need to recalibrate?
So after the thing, I managed to print out on a sticky paper my own cluster design.
Question, ok i can remove my dash after disconnecting the cable from the gearbox. All fine... I can pry it open... that too...
But after removing the needles do i need to recalibrate?