JJS_Puma
New member
Hi all.
Have just extended the lambda sensor loom for fitting to sensor on a Milltek 4 branch manifold, later type with the section of flexi pipe built in.
Any suggestions/ ideas on the best route for the bit of loom with plug on to go down to lower part of manifold where the sensor is??.
Pictures would be brilliant, but I know it's difficult!.
Many thanks, Jim.
Have just extended the lambda sensor loom for fitting to sensor on a Milltek 4 branch manifold, later type with the section of flexi pipe built in.
Any suggestions/ ideas on the best route for the bit of loom with plug on to go down to lower part of manifold where the sensor is??.
Pictures would be brilliant, but I know it's difficult!.
Many thanks, Jim.
