just fitted the front discs and pads and cailpers off an st200, they work a treat, really really well. However after just a few high speed applications they lock on, hard, the only way to release them is to let out some of the fluid.
right the brakes were working perfectly two days before on the car I took them off.
when I release the pressure they open immediately..so no sticking piston etc...or bad discs.
I have changed a few of the hoses and the master cylinder, the brakes have always since I had it been a bit spongy, and ineffective hence the upgrade to the st 200, I intend to do this for the other std puma too even thought its brakes are not bad...
the back brakes are awful, the handbrake is bad...i have changed the wheel cylinders on the back...
any help or ideas as I am running out of things to change...and I dont have a puma I can use at the moment
right the brakes were working perfectly two days before on the car I took them off.
when I release the pressure they open immediately..so no sticking piston etc...or bad discs.
I have changed a few of the hoses and the master cylinder, the brakes have always since I had it been a bit spongy, and ineffective hence the upgrade to the st 200, I intend to do this for the other std puma too even thought its brakes are not bad...
the back brakes are awful, the handbrake is bad...i have changed the wheel cylinders on the back...
any help or ideas as I am running out of things to change...and I dont have a puma I can use at the moment