Hi folks, I've been working away on my car, when the back box fell of due to rust, after having a look at the rest of the exhaust, its pretty knackered. So I'm looking for some advice on how to get it out.
So far I've remove the top heat shield and bolts from the manifold, and the bolts from the top of the cat. Underneath, I had to remove the driveshaft, the extra bit that joins onto the hub. Not sure if I've missed anything.
So the next question is what to get to replace it, a mate has a 4/2/1 manifold stainless that he didn't use, and was thinking about using that, the car is for road use, so I'm guessing it'll need a cat also, any ideas what I can use, or am I best just getting ford parts.
Any help / advise would ne great.
So far I've remove the top heat shield and bolts from the manifold, and the bolts from the top of the cat. Underneath, I had to remove the driveshaft, the extra bit that joins onto the hub. Not sure if I've missed anything.
So the next question is what to get to replace it, a mate has a 4/2/1 manifold stainless that he didn't use, and was thinking about using that, the car is for road use, so I'm guessing it'll need a cat also, any ideas what I can use, or am I best just getting ford parts.
Any help / advise would ne great.