Hello! From Portugal!

New to ProjectPuma? Just got your first Puma? Looking to buy? This is the place to introduce yourself!

Moderator: Moderators

Post Reply
ahlidap
Newbie
Newbie
Posts: 2
Joined: Wed Jun 28, 2017 7:10 pm
Model: 1.7

Hello! From Portugal!

Post by ahlidap » Fri Jan 18, 2019 11:57 am

Hi!

I'm writing from Portugal, and I've bought a PUMA 1.7 VCT from October 1997, about 2 years ago.
It was almost abandoned, and I just needed to rescue it!

Since I bough it I've been struggling with ABS and TC (damn!).
From time to time it started to randomly bring ABS and TC Lights on..

Delphi diagnostic software said it was left rear wheel problem.
Both rear sensors were replaced with new ones from "ABS".

Lights now are always on, even after the grinding sound.
Lately I realized I bough sensors for post 1999 model :oops:

Everything bolt on.. are they really different?
I've always read about same ohms resistance for measure, without specifying any year of the vehicle.

Delphi software doesn't show any error.
Delphi software never got real time readings (this would help a lot).


Any of you have any suggestion?
As far as I know ABS module is responsible for distributing "brake force".. and currently I feel it's really braking more at one side..

I really want to fix this.
Any help will be much appreciated!

Thank you guys ;)
0 x

User avatar
red
Site Administrator
Site Administrator
Posts: 11061
Joined: Wed Oct 03, 2007 4:31 pm
Model: Other
Location: Cambridgeshire
Contact:

Hello! From Portugal!

Post by red » Fri Jan 18, 2019 4:18 pm

Are your tone wheels in good clean condition?
Is the loom ok? (I assume yes if you get no errors)
AFAIK the resistance readings are the same for all.

One thing to consider is that the drum size did change mid production and maybe there were actually differences on the sensors to accommodate?

You've probably already tried this, but if not:
To test the sensors:

1. Remove Wheel
2. Remove Inner Arch Lining
3. Unplug ABS Sensor
4. Set Multimeter to Ohms
5. Set Range so meter reads between 1000 and 1200 Ohms
6. Test the sensor plug LEADING to the wheel hub by going across the 2 pins
7. A good sensor should read between the values with an average of 1.1K Ohm
8. Anything else can point to coils breaking down
9. Remember to wiggle the sensor lead when testing to check the internal coils
10. Repeat if necessary on other side.
0 x
FRP#0201 (2000) 2009-2011
Melina Blue (1999) 2006-2009
Moondust Silver (2000) 2006

Post Reply

Return to “Newbie Area”