Search results

Ok thankyou :-)

Is the gasket for the Idle Control Valve on the 1.7 a rubber type or a paper type and can it be reused? If not what is the part number for a new one? Reason i am asking is because my idle has gone rough so want to take the valve off to either clean or replace.

Would the light need resetting with a code reader or would it eventually come back on again?

My mate has an escort rs turbo and it is running at 200 bhp. He changed the bottom end to a 2 litre zetec but i dont know what car it was from, uprated his injectors and had it remapped.

Just changed the Lambda sensor on the manifold due to poor fuel economy, hesitation and the occasional misfire. Problem is though after i finished i disconnected the battery for half an hour to reset the ecu and then i went for a little drive to test it which went well until i got back and...

Anyone know?

Try pressing the bonnet switch on the slam panel and see if the light goes out. Its best to have 2 people unless you've got extra long arms :lol:

Will the ntk OZA519-D1 fit the 1.7?

Just spoke to the company who i purchased the sensor from and they can't find a sensor with a round connector and that front and back should be the same which they are clearly not. Does anyone know if the 1.6 has the round connector and if so is it the same as the 1.7 so then i could maybe try...

Are there different shape plug connectors for the front lambda sensor on the 1.7's as i have just bought a ntk and it has a black square connector but my car has a green round connector?

Take a look at this http://www.projectpuma.com/viewtopic.php?f=51&t=7991

Better start buying my brake bits then for when i fit larger wheels :grin:

Are the mk3 mondeo calipers from a specific model or are they all the same?

I am also going to give the icv a clean to see if the power picks back up a bit but have read about replacing the gasket. Does this need to be done and if so can someone tell me the part number for it? :-)

It was this pulley I think its the idler pulley. Was yours making a noise and do you have a part number for the tensioner underneath the pump?

I have got a rattling type of sound coming from the belt side of the engine. The aux belt and pulley has been replaced but the noise is still there. I have just been out to have a good listen and it sounds like its the power steering pump so checked the fluid which is at the max line but is...

I forgot to mention that since the noise started the aux belt, idle pulley, spark plugs, air filter and coil pack have been changed but not stopped the noise. I'm 100% sure its something to do with the oil change. Valvolene 5w 30 grade oil was used. Anyone got any idea of what the cause could be?

Ok i thought it would of done. The reason i ask is because i had my oil changed at the garage the other day and the engine has been noisy ever since and i can hear a rattleing noise coming from the the front o/s wheel arch when idling which i think could be something to do with the vct so...

Is the oil filler cap supposed to have some sort of rubber ring or something to seal it?

I have just been out to change my fuel filter but when i removed the old one i couldnt remember which way it was so dont know if im fitting the new one the right way. Is the fuel flow arrow supposed to point towards the drivers side or the passenger side?