warrenpenalver
Active member
Im after a favour from someone.
Can someone get a blob of bluetack/plasticine/foam or similar and squish it between the top of the idle speed control valve at highest point and the bonnet.
With my supercharger conversion I need to fit a take off to feed air to the idle control valve. So Im raising up the idle control valve using a adaptor from a KA that allows me to fit a take off so i dont have to modify an original inlet. However it raises the idle control valve about 40mm.
Without a fitted engine yet, I'm after the measurement so i know it will fit.
Any help would be appreciated!!
Can someone get a blob of bluetack/plasticine/foam or similar and squish it between the top of the idle speed control valve at highest point and the bonnet.
With my supercharger conversion I need to fit a take off to feed air to the idle control valve. So Im raising up the idle control valve using a adaptor from a KA that allows me to fit a take off so i dont have to modify an original inlet. However it raises the idle control valve about 40mm.
Without a fitted engine yet, I'm after the measurement so i know it will fit.
Any help would be appreciated!!