My rust quest continues this weekend,
Started poking around the sills to find rust, most of it was solid with surface rust, chipped away at the stone chip protection to find fresh metal around the rust
however a couple of places had rusted through forming little holes.
The most concerning being near a seat mount plate point, luckily the plate itself was solid, but the rust and hole definatlely needed attention
Had to remove the seat to get to the other side of it
[img]http://www.corsasport.co.uk/carimages/9307/P1050615.JPG
So guaged all the loose rust out and surrounding edges until i found clean metal, then i applied rust kill paint to all point that were rusty
Then applied epoxy metal putty to the holes, probably not the best method but should at least hold it off from getting worse
Sanded the putty nice and smooth so it blends in and painted over the repairs
Once all that had dried, then went over with underseal paint
Area which has been repaired